1. Hand cream for adhesive Velcro
First tear off the printed matter on the surface, then squeeze some hand cream on it, and slowly rub it with your thumb. After rubbing for a while, you can rub off the adhesive residue. Just a little slower. Hand cream belongs to oil substances, and its properties are incompatible with gums. This feature is used to remove glue.
2. Banana water for adhesive Velcro
It is an industrial agent used to remove paint, and it is also easy to buy (it is sold where the paint is sold). The method is the same as that of alcohol and acetone.
3. Wipe it with a paper towel dipped in some alcohol (preferably industrial alcohol, or it's OK not to use medical alcohol), and then rub it a few times to clean it.
4. With acetone
The method is the same as above. The best thing is that it can quickly and easily remove these residual colloids, which is better than alcohol.
5. Use nail washing water
The usage is the same as alcohol acetone. The effect is also very good. Nail washing water does not require quality. Good or ordinary nail washing water is OK as long as it can wash off nail polish.
6. When using gasoline, you should pay attention at this time, because gasoline dissolves some plastic or paint, so you must use it carefully: either wipe and observe the unimportant place now, and use the Velcro strap if there is no problem, but you must be careful not to use too much gasoline, and the time should be as short as possible.
